Home    Company Information    What's New    Contact Us   

 
Reaction Torque Sensor
non-contact torque sensor / slip ring torque sensor / reaction torque
prefab torque & thrust sensor / load pins & cells



Model 12328
Model 12328
It is often the case that torque in a rotating shaft can be measured with a stationary, reaction torque sensor at some point in the powertrain. This is due to the existence of an equal and opposite force (torque) necessary to hold the drive and driven equipment in place.

For example, the torque to drive a pump at a constant speed can be measured as the static torque necessary to hold the pump or the motor from rotating.
model 15228
Model 15228
The reaction torque approach is often less costly and because reaction torque sensors have no moving parts, requires no maintenance. Reaction torque sensors are recommended in lieu of rotary torque sensors when steady-state measurements are acceptable.

Teledyne Instruments offers a complete line of Reaction Torque Sensors in capacities from 10 in-lb to 250,000 in-lb. All of our sensors utilize strain gages and are maintenance free with no moving parts. Reaction Sensors are used in applications where in-line torque measurements are required and angular motion is limited.

Applications:
Mixers -- Dynamometers -- Pumps -- Motors -- Research & Development

Specifications:

PERFORMANCE
Output at Rated Torque 1.5 to 3 mV/V nominal
Calibration Accuracy 0.25% F.S.
Overload Rating 150%
Excitation Maximum dc to 10V
Bridge Resistance 350 ohms
Zero Balance 1% F.S.
Temperature Effect on Zero 0.0025%
Compensated Temperature Range 72F - 150F +/- 3F
Connector MS 3110P-8-4P or equivalent


   


Home | e-mail: sales_testservices@teledyne.com

Copyright 2012 Teledyne Technologies Incorporated. All rights reserved.
Teledyne Test Services • 513 Mill Street • Marion, MA 02738 • USA